M-BAND-10 Magnetic band

For magnetic measuring systems MPI-R10 and MPI-15

 
 

Select item

loading

Technical specifications

Scroll horizontally
Main specifications

Standard execution

The magnetic band M-BAND-10 is made of two separate parts: the magnetic band and the cover strip. The magnetic band is made of a magnetic tape, a carrier strip and an adhesive tape (Fig.2). The cover strip is made of a protection strip and an adhesive tape (Fig.1).

M-BAND-10 - Magnetic band 
Other executions

Special executions on request

Magnetic band with length different from the standard executions shown in the table, up to 25 m maximum.

Instructions of use

Assembly instructions

  • The cover strip must be installed over the magnetic band to protect it against possible mechanical damages.
  • Clean the mounting surface carefully.
  • Remove the protective foil from the adhesive tape of the magnetic band.
  • Stick the magnetic band on the mounting surface.
  • Clean the mounting surface carefully.
  • Remove the protective foil from the adhesive tape of the magnetic band.
  • Stick the cover strip on the magnetic band. (Fig.3)
  • In the absence of a seat for the housing of M-BAND-10, secure the ends of the cover strip to prevent unintentional peeling.
Technical data
Precision± 40 μm
Materialmagnetic tape: nitrilic rubber
carrier strip: stainless steel
cover strip: stainless steel
acrylic adhesive tape
Widthmagnetic band: 10 mm ± 0.20 mm
cover strip: 10 mm ± 0.20 mm
Thicknessmagnetic band: 1.43 ± 0.15 mm
cover strip: 0.23 mm
Magnetic pole pitch5 mm
Operating and storage temperature-40 ÷ +100 °C
Linear thermic expansion factor17 x 10-6/K
Elesa
Models all rights reserved in accordance with the law. Always mention the source when reproducing our drawings and photos.

ASK THE EXPERT

This site is protected by reCAPTCHA Enterprise and the Google Privacy Policy and Terms of Service apply.